RC ERA C129 V2 Bearing Set Replacement Bearings for 4CH RC Helicopter

Eliminate Shaft Friction, Fix Rotor Grinding, and Restore Smooth Flight Performance

Worn, dirty, or seized main shaft bearings on your RC ERA C129 V2 4CH RC Helicopter cause excessive mechanical resistance, leading to motor overheating, reduced battery flight times, and harsh grinding noises. Accumulated dust, sand, or moisture inside the bearing raceways can cause the main rotor shaft to bind or wobble, which interferes with the 6-axis gyro stabilization and results in erratic flight behavior or altitude drops. Replacing damaged bearings with makeshift hardware often leads to improper gear mesh and premature motor failure. This official replacement RC ERA C129 V2 Bearing Set completely solves rotational friction and rotor shaft slop. Precision-engineered to exact factory specs, these high-grade micro ball bearings ensure silky-smooth shaft rotation, minimize power loss, and protect your helicopter’s drive train.  Ships worldwide.

Product Highlights

• High-Grade Steel Ball Architecture: Manufactured with hardened steel races and precision micro balls to handle high rotational speeds without friction or play.

• Dual-Shielded Dust Protection: Built with protective shields to keep dirt, carpet fibers, and debris out of the internal raceways, ensuring long-lasting smooth performance.

• Optimized Power Efficiency: Reduces motor load and power loss, helping restore long flight times and smooth throttle response.

• Factory-Matched Dimensions: Engineered specifically for the RC ERA C129 V2 main frame and main shaft for a flush, vibration-free fit.

Compatibility

For the RC ERA C129 V2 4CH RC Helicopter only.
Full model page (specs & photos):
https://kadstoylover.com/products/rc-era-c129-v2-4ch-brushless-rc-helicopter

What’s in the Box

• 1 * RC ERA C129 V2 Bearing Set

Install Tips

• Disassembling Main Shaft Assembly: Remove the main rotor blades, disconnect the swashplate linkages, and unscrew the main drive gear locking pin to slide the main shaft out of the chassis.

• Removing Old Bearings: Gently press or pop the worn micro bearings out of their upper and lower mounting sockets on the main frame chassis using a small hex driver or pin tool.

• Seating New Bearings: Push the replacement bearings squarely into the main frame bearing seats until they sit completely flat and flush within the housing.

• Reinstalling Main Shaft and Gear: Slide the steel main shaft back through both new bearings, reattach the main drive gear and swashplate linkages, and spin the shaft manually to verify smooth, silent rotation before flight.

Support & Warranty

• 3-month warranty on manufacturing defects
• Ships worldwide